nativeInstallerlamp

Disable PHP-FPM

NOTE: The Approach A sections referred to below do not apply to Bitnami native installers. Users of Bitnami native installers should refer only to the Approach B sections.

To disable an already enabled PHP-FPM configuration, follow these steps:

  • Disable the mpm_event module by commenting the LoadModule directive:

      #LoadModule mpm_event_module modules/mod_mpm_event.so
    
  • Enable the mpm_prefork module by uncommenting its LoadModule directive:

      LoadModule mpm_prefork_module modules/mod_mpm_prefork.so
    
  • Enable the php7 module by uncommenting its LoadModule directive:

      LoadModule php7_module  modules/libphp7.so
    
  • Restart Apache:

      $ sudo installdir/ctlscript.sh restart apache
    
  • Stop PHP-FPM:

      $ sudo installdir/ctlscript.sh stop php-fpm
    
  • Disable the PHP-FPM service: Depending on your installation type, run the following commands:

    • Approach A (Bitnami installations using system packages):

        $ sudo mv /etc/monit/conf.d/php-fpm.conf /etc/monit/conf.d/php-fpm.conf.disabled
        $ sudo gonit reload
      
    • Approach B (Self-contained Bitnami installations):

        $ sudo mv installdir/php/scripts/ctl.sh installdir/php/scripts/ctl.sh.disabled
      
Last modification June 16, 2021